Hide Notes 

Slide 1: 199-01 Riverbed Certified Solutions Professional Exam: 199-01 Demo Edition © 2008 - 2009 Test Killer, LTD All Rights Reserved 1 http://www.testkiller.com http://www.troytec.com
Slide 2: 199-01 QUESTION: 1 When enabling WCCP v2 support, what does a multicast TTL value of 1 imply? A. This enables WCCP v2 support B. The Steelhead appliance uses a multicast scope of 1 hop C. This enables WCCP multicast D. This enables WCCP unicast Answer: B QUESTION: 2 A server-side logical in-path deployment is shown in the accompanying figure. Additionally, SH12 is configured with a fixed target rule pointing to SH11. The client behind SH12 will not be able to establish a connection to SERVER1 as a logical loop will occur when the number of optimized connections in SH11 has reached the maximum system limit. What is the best way to resolve this issue? A. Use the largest Steelhead appliance model B. Enter the "in-path loopguard enable" command C. Use more than one Steelhead appliance D. Limit the number of TCP connections to be optimized E. Put SERVER1 in a different subnet from SH11 2 http://www.testkiller.com http://www.troytec.com
Slide 3: 199-01 Answer: E QUESTION: 3 In configuring failover settings, which of the following interfaces is used for communicating with the backup Steelhead? A. inpath0_0 B. inpath0_1 C. Primary D. AUX E. None of the above Answer: D QUESTION: 4 Place the following procedures to upgrade a Steelhead appliance from the CLI in the correct order. (Note: include only necessary steps) 1) SH (config) image install image.img 2 2) SH (config) image fetch http://server/path/image.img 3) SH (config) boot system 2 4) SH (config) restart clean 5) SH (config) reload 6) SH (config) write memory A. 1.2.3.4.5.6 B. 2.3.5.1.6 C. 1.2.5.4 D. 2.1.3.6.5 E. 1.2.3.6.5 Answer: B QUESTION: 5 In the accompanying figure, Client41 and Client42 have full access to the HTTP and FTP services provided by Server31 and Server32 respectively. They continue to have access to these servers after SH3 and SH4 are deployed. A quick check on SH3 and SH4 registers the connections from Client41 and Client 42 as pass-through traffic. Note that SH3 and SH4 are in autodiscovery mode. What are the likely causes? (Select 2 responses) 3 http://www.testkiller.com http://www.troytec.com
Slide 4: 199-01 A. Pass-through rules are specified in the Steelhead appliances to bypass to bypass TCP traffic from Client41 and Client42 B. Pass-through rules are specified in the Steelhead appliances to bypass to bypass IP traffic from Client41 and Client42 C. There is a firewall inside the WAN cloud which strips the TCP option field rendering the auto-discovery probe irrelevant D. There is a firewall inside the WAN cloud which strips the IP option field rendering the autodiscovery probe irrelevant Answer: A,C 4 http://www.testkiller.com http://www.troytec.com